How to install PVC/SPC skirting boards – A practical guide

714

How to install PVC/SPC skirting boards – A practical guide

Installing a skirting board is an important stage of interior finishing, which can significantly improve the aesthetics of the room while protecting the lower parts of the walls. In the article we present a simple guide on how to install PVC/SPC skirting boards yourself.

Tools and materials needed

Before you start working, make sure you have the following tools and materials on hand:

  • Measuring tape
  • A saw with a thin blade
  • Mounting glue (strong double-sided tape or sealing compound)
  • Seal squeezer
  • Spirit level

Step 1: Measure and cut the skirting board

The first step is to carefully measure the wall to which you will install the strip. Use a measuring tape to get a precise measurement. Then cut the strip to the appropriate length using a saw with a thin blade, which will ensure a smooth and aesthetic cut.

Step 2: Apply adhesive

After preparing the strip, apply glue to its back side. You can use strong double-sided tape or sealing compound. If you choose tape, make sure it is strong enough to hold the molding in place. If you decide to use sealing compound, spread it evenly using a squeezer.

Step 3: Installing the skirting board

Start at one end of the wall, pressing the strip against the surface. Use a level to make sure the molding is perfectly level. Continue this process along the entire wall, making sure the strip fits evenly along its entire length.

Installation in corners

and) External corners
For external corners, place the strip against the wall and mark where to cut at an angle. Set the miter saw to 45 degrees and cut the strips to fit the ends exactly. If the joint is too tight, lightly sand the edges.

b) Internal corners
For inside corners, first cut one strip to length with a straight cut. Then, using a miter saw, make a diagonal cut at an angle of 45 degrees to fit the moldings. Sand the edges and fit the strips into the corner.

Step 4: Finish assembly

Finally, fill any gaps between the molding and the wall with sealant. Apply it in an even layer using a squeezer, and then smooth it out for an aesthetic final effect.

Installing a skirting board is not a difficult task, but it requires precision and care. With the right tools and following the steps, you will achieve a perfect result that will complement your interior design.

Contact

or fill in the form

    Nobless Polska Zbigniew Sierzputowski Sp. k.
    ul. Skrajna 3B, Sierosław,
    62-080 Tarnowo Podgórne,
    NIP: 7831742179, REGON: 364482735, BDO: 000305723, KRS no.: 0000618619,
    District Court Poznań - Nowe Miasto and Wilda in Poznań, 8th Commercial Division

    Follow us